Thank you so very much! Now we can put the word out that it’s finally up and working perfectly!Īfter posting, I see they changed back again so just be sure the quotes around the bond token and argument is " and not “. Tigo má api, které fungnuje, ale zdaleka tam nemá vechny dostupné parametry. Thank you for your interest and for taking part. On another forum I saw a mention of 10k, so maybe the exact number doesnt matter, I guess there is a certain range of resistors that can get it to work.
I changed them here so I hope they stay the correct format and not “italicized“. Diskuzní fóra Loxone SW i HW Tigo + NodeRED Tigo + NodeRED Last Post RSS Dáda (vary) Honorable Member Moderator Joined: 6 years ago Posts: 725 Topic starter 1:07 pm Zdravim, eím propojení TIGO optimizér do Noderedu. Loxone Support Community Loxone Archive: Loxone Support Community An open platform for Loxone Partners and consumers alike for advice, sharing expertise and discussions on what is possible. Correspondence address: The Forum, Station Road, Theale, Reading, United Kingdom, RG7 4RA. On high sensitivity, you can program Loxone to interpret the level of motion or presence, based on pulse width and/or counting pulses.'. It is as above here except when copying, the quotes have to be the correct format. As the Motion sensor provides a pulse when motion is detected technically this can be connected to any function block in Loxone config that is looking for a pulse/digital input. These are the attributes and then a couple commands I can execute successfully from the cmd directly… First, we are going to look at where to connect the motion sensing digital input within the Loxone config software. I’ve tried breaking up the command a few different ways so far. Create a program block which takes the output from the lighting controller as an analogue input (AI1 - AI13) 5.
In Loxone Config add a device to a lighting controller as an RGB output.
But collecting votes here in the forum for the feature request certainly helps to increase. Connect each lamp to your desired group on a wifi controller as per instructions supplied with device. I can work on fan speed/on/off secondary. in Loxone i cant use cURL commands but only http commands. The primary function I’d like to get working is the light portion.
0 kommentar(er)
